EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » Don`t Remember the Eagle Grid setting
Don`t Remember the Eagle Grid setting [message #171284] Sat, 12 August 2017 19:10 Go to previous message
Dhiraj Gehlot
Messages: 1
Registered: August 2017
Junior Member
Hello Everyone,

I am using eagle 7.6.0. My friend made a schematic and board layout of a PCB. He send me the files for editing.
He used some grid setting which he don`t remember.
If I open the file to edit the schematic with my default grid setting, the net are not snapping to the pin terminals of the components.
Is there any way to open the file with grid settings with which the file was saved?
Or Is there any other reason for which I am unable to snap the pin terminals of the components?

Best regards,

To view any images and attachments in this post, visit:
Read Message
Read Message
Read Message
Previous Topic: Which file contains user settings for EAGLE?
Next Topic: Ratsnets desition make based on different layer
Goto Forum:

Current Time: Tue Sep 26 16:22:59 GMT 2017