EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » Double Side Eagle
Double Side Eagle [message #171518] Tue, 29 August 2017 22:50
Gabriella Shull
Messages: 1
Registered: August 2017
Junior Member
I would like to create a board that is double sided using the free version of eagle. I would like the bottom side to be an exact copy of the top side, but isolated from one another (I am not using any vias or through hole components). I have a board layout of the design, but I am not sure how to go about this. Should I just copy the group with all connections in the board layout, overlap them 100% and simply label one top and one bottom? I am new to Eagle so any help is appreciate, I apologize if it is a trivial question. Thanks in advance!

To view any images and attachments in this post, visit:
Previous Topic: Changing Computers
Next Topic: Rasperry PI 2 B Vers 1.1
Goto Forum:

Current Time: Wed Sep 20 21:54:53 GMT 2017