EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » When I place pads, they're invisible
When I place pads, they're invisible [message #170805] Wed, 21 June 2017 20:55 Go to next message
Nate Weiler
Messages: 7
Registered: June 2017
Junior Member
I'm creating a package in Eagle 6.5.0 Light, and when I place pads, they're invisible. It happens when I change the diameter of the pad to the diameter of the pins in the device datasheet. How can I fix this? I need to make a schematic for a system I'm designing. The desired diameter is 0.457 mm +- 0.127 mm. Thanks

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/224485
Re: When I place pads, they're invisible [message #170807 is a reply to message #170805] Wed, 21 June 2017 21:08 Go to previous message
Nate Weiler
Messages: 7
Registered: June 2017
Junior Member
I discovered that I need to change the drill value. That fixed it.

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/224531
Previous Topic: Unable to see the copper pour on the PAD though the thermels is off
Next Topic: tcream layer areas missing
Goto Forum:
  


Current Time: Wed Jul 26 12:42:25 GMT 2017