EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Disconect between Schem and PCB (Element 14 :: EAGLE Related Posts)
Disconect between Schem and PCB [message #169310] Wed, 08 February 2017 15:39 Go to next message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
I have been working on a PCB for several days, there are a lot of connections and I have been ripping and rerouting a lot. I save the project often to preserve what I have done so far. Yesterday I worked on the PCB for about 4 hours, saving as I when along, at the end of the day when I closed the PCB screen, I saw with horror a yellow waning sign at top of the schematics telling me that there are no longer connected. I don't know what I did, but I suspect that when ripping one of the traces I pressed the delete key and did not pay attention to the message telling me that I will lose the connection to the schematic.Is there any way to save what I have done?
EAGLE support forums at www.eaglecentral.ca :: Where the EAGLE community meets.

Original article at https://www.element14.com/community/message/215387?tstart=0#215387
Re: Disconect between Schem and PCB [message #169311 is a reply to message #169310] Wed, 08 February 2017 15:46 Go to previous message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
Hi Daniel, If the yellow bar came in the schematics after you closed the PCB you are fine as this is normal. It's as a warning to you not to make changes to the schematic while the PCB is closed or vice versa. If however you are seeing this in both the schematic and PCB when they are BOTH loaded then you have an inconsistency between the two which you will need to resolve. In this case run the ERC to find out where the errors are. Best Regards, Rachael
EAGLE support forums at www.eaglecentral.ca :: Where the EAGLE community meets.

Original article at https://www.element14.com/community/message/215484?tstart=0#215484
Previous Topic: renumber schematic
Next Topic: EAGLE 8.0.1 Released!
Goto Forum:
  


Current Time: Thu Aug 17 02:01:20 GMT 2017