EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » regarding pcb connection for mosfet
regarding pcb connection for mosfet [message #169069] Sat, 28 January 2017 16:21
srinivasan m
Messages: 5
Registered: January 2017
Junior Member
hello guys.
CSD18512Q5B 40V N-Channel NexFET™ Power MOSFET | TI.com ( https://www.element14.com/community/external-link.jspa?url=http%3A%2F%2Fwww .ti.com%2Fproduct%2Fcsd18512q5b%2Fdatasheet)​     This is the mosfet im going use for my work. I'm using it for buck convertion. In this package type there are various drains and source for dissipating large amount of current. Can anybody say how to connect these in PCB board layout to connect products. I read that all similar drain's and source's must be connected within PCB for best efficiency of the IC. can anyone elaborate how to make connection in the PCB board.
suggestions are welcome. thanks in advance.

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/214589
Previous Topic: mosfet dilemma
Next Topic: How to remove/add through hole plates on vias when I export gerber files to reduce the cost?
Goto Forum:
  


Current Time: Fri Jun 23 18:50:16 GMT 2017