EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » Why are both nets going to the same end of resistor in board layout?
Why are both nets going to the same end of resistor in board layout? [message #168179] Wed, 28 December 2016 01:30 Go to next message
Boyd Roberts
Messages: 1
Registered: December 2016
Junior Member
Hi guys. When I open the board layout view, I have a resistor with the nets coming off the same end. I want the resistor wired correctly (wires on both ends). Thanks

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/211876
Re: Why are both nets going to the same end of resistor in board layout? [message #168183 is a reply to message #168179] Thu, 29 December 2016 10:55 Go to previous message
rachaelp
Messages: 609
Registered: March 2015
Location: UK
Senior Member
Boyd Roberts wrote on Wed, 28 December 2016 01:30
Hi guys. When I open the board layout view, I have a resistor with the nets coming off the same end. I want the resistor wired correctly (wires on both ends). Thanks


Check the name of the net on each side of the resistor in the schematic. I suspect you have somehow named them the same.

Best Regards,

Rachael
Previous Topic: drillegend-stack.ulp
Next Topic: Getting rid of silkscrean on bPlace layer
Goto Forum:
  


Current Time: Wed Oct 18 22:13:58 GMT 2017