EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.support.eng » drillegend-stack.ulp
drillegend-stack.ulp [message #168177] Tue, 27 December 2016 20:40 Go to next message
Martin[17]
Messages: 5
Registered: March 2011
Junior Member
Hello,

Have a problem with Eagle 7.6 and the drillegend-stack.ulp. This is
one of the ulp's shipped with Eagle.

I run the ULP and it places a table on Layer 144. But I cannot edit
it, and I cannot select it as a group.

Is there an Updated ULP to create a legend? Or a way to select the
table?

Thanks

Martin
Re: drillegend-stack.ulp [message #168178 is a reply to message #168177] Tue, 27 December 2016 20:48 Go to previous message
Martin[17]
Messages: 5
Registered: March 2011
Junior Member
On Tue, 27 Dec 2016 15:40:35 -0500, Martin Riddle
<martin_rid@verizon.net> wrote:

> Hello,
>
> Have a problem with Eagle 7.6 and the drillegend-stack.ulp. This is
> one of the ulp's shipped with Eagle.
>
> I run the ULP and it places a table on Layer 144. But I cannot edit
> it, and I cannot select it as a group.
>
> Is there an Updated ULP to create a legend? Or a way to select the
> table?
>
> Thanks
>
> Martin

Oh never mind. I found the Menu of the table is on the tOrigins
layer. With out it showing, you can't move the table.

Cheers
Previous Topic: AC Source Eagle
Next Topic: Why are both nets going to the same end of resistor in board layout?
Goto Forum:
  


Current Time: Sat Mar 25 15:32:08 GMT 2017