EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » How to merge several *.brd files into one? (Element 14 :: EAGLE Related Posts)
How to merge several *.brd files into one? [message #168026] Fri, 09 December 2016 20:54 Go to next message
messages@element14.co
Messages: 563
Registered: March 2013
Senior Member
Hi. I have 3 sch different files with their corresponding brd files. Is there a way to merge the brd files into one? ThanksOriginal article at https://www.element14.com/community/message/210870?tstart=0#210870.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: How to merge several *.brd files into one? [message #170604 is a reply to message #168026] Wed, 31 May 2017 07:31 Go to previous message
messages@element14.co
Messages: 563
Registered: March 2013
Senior Member
Hi Fabian, Dont know if u figured this out or not, but you can try doing the following: 1. Open 3 instances of eagle software2. Group the schematic, Copy them to put the data in the buffer3. Paste in the "main" schematic file If you can try pasting them in different sheets Hope I am not too late? lol
EAGLE support forums at www.eaglecentral.ca :: Where the EAGLE community meets.

Original article at https://www.element14.com/community/message/223233?tstart=0#223233
Previous Topic: How to remove value from showing up on board layout without modifying part in library
Next Topic: Off the points grid
Goto Forum:
  


Current Time: Wed Sep 20 02:13:25 GMT 2017