EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » How do I get an always uptodate rats nest? (Element 14 :: EAGLE Related Posts)
How do I get an always uptodate rats nest? [message #167255] Fri, 23 September 2016 14:28
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member
Hi,  I am new to eagle, that's why this is a beginner's question. Lets assume a simple example: A resistor's pad is connected to two other devices. Lets further assume I placed those two devices at opposing sites of my board. When I move the resistor around the rats nest shows only the connection to one of the devices, even if I place it directly next to the other (which would be the short distance). Another design tool (KiCad) which I used so far always draws a line to the nearest point of the same net, even while moving parts around. Can eagle do this and how do I enable this? thx in advance!Original article at https://www.element14.com/community/message/206167?tstart=0#206167.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Atmega328 - Newbie design
Next Topic: Colorsound Power Boost Clone
Goto Forum:
  


Current Time: Tue Mar 28 02:17:18 GMT 2017