EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.suggest.eng » Please improve the netclass editor
Please improve the netclass editor [message #167038] Fri, 09 September 2016 17:43 Go to next message
Joop_
Messages: 67
Registered: March 2007
Member
Dear Cadsoft team,

Could you be so kind to considder the following addition to the netclass editor:

Make it possible for a given netclass, to set the trackwidth and clearance separately for every layer.

When routing a highspeed differential pair, it's a pain in the a*s to change the netclass everytime
when you change from an inner to an outer layer...

Thanks.
Re: Please improve the netclass editor [message #167058 is a reply to message #167038] Mon, 12 September 2016 07:10 Go to previous message
Morten Leikvoll
Messages: 1343
Registered: November 2007
Senior Member
On 09.09.2016 19:43, Joop wrote:
> Dear Cadsoft team,
>
> Could you be so kind to considder the following addition to the netclass
> editor:
>
> Make it possible for a given netclass, to set the trackwidth and clearance
> separately for every layer.
>
> When routing a highspeed differential pair, it's a pain in the a*s to
> change the netclass everytime
> when you change from an inner to an outer layer...
>
> Thanks.
>
Similar topics has requested before, and I think it needs involvement of
the stackup editor.

Maybe eagle could just as well allow you to add all pcb parameters
material properties so you could just specify class impedance and get
the layer widths automatically updated, even after stackup changes.
Previous Topic: Apparent Bugs in Yageo/Eagle Library
Next Topic: Moving piece of wire with label attached
Goto Forum:
  


Current Time: Thu May 25 12:27:45 GMT 2017