EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.suggest.eng » How make appear only GND on layout ?
How make appear only GND on layout ? [message #166479] Fri, 05 August 2016 15:44 Go to next message
djib ty
Messages: 9
Registered: July 2016
Junior Member
Hello,

I want to test the connection on the PCB layout on Eagle between my components and I would like to see if the components areĀ  well linked to GND or VCC for example.
Is it possible to make appaear only GND vias/wires on the layout ?

Regards, djib.

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/203204
Re: How make appear only GND on layout ? [message #166481 is a reply to message #166479] Sat, 06 August 2016 07:46 Go to previous message
Tilmann Reh
Messages: 2066
Registered: October 2004
Senior Member
djib ty schrieb:

> I want to test the connection on the PCB layout on Eagle between my
> components and I would like to see if the components are well linked
> to GND or VCC for example.
> Is it possible to make appaear only GND vias/wires on the layout ?

Not directly.

However, SHOW GND will highlight this signal - with properly set colors,
this provides exactly the information you want.

Tilmann
Previous Topic: Layer Abuse - how bad is this?
Next Topic: dlgListView and keyboard
Goto Forum:
  


Current Time: Thu Mar 23 08:06:55 GMT 2017