EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Eagle : Creating a footprint for a 4 pin connector (Element 14 :: EAGLE Related Posts)
Eagle : Creating a footprint for a 4 pin connector [message #166332] Thu, 21 July 2016 15:30
Messages: 565
Registered: March 2013
Senior Member
Hello everybody, I am a newbie with Eagle and I had to create a footprint for a 4 pin connector.This connector will be created for this component, it is a gas sensor : http://www.alphasense.com/WEB1213/wp-content/uploads/2013/07/NH3B1.pdf First, I created the schematic file and I found a connector in the libraries. I used this one : 4POL254  (phoenix connector MPT4)Obviously, it didn't correspond to the connector I wanted.I think that I will need to create the connector with the right dimensions thanks to the datasheet but I didn't know how to do exactly.If someone could help me, thanks.Original article at https://www.element14.com/community/message/201999?tstart=0#201999.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: bluetooth headset project using MCU and bluetooth module
Next Topic: Arduino 2.4 tft lcd
Goto Forum:

Current Time: Wed Oct 18 04:02:14 GMT 2017