EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.userchat.eng » Re: Strange solder mask openings
Re: Strange solder mask openings [message #165582] Mon, 25 April 2016 09:07
Richard Hammerl
Messages: 2536
Registered: October 2004
Senior Member
If you see it in the Gerber data it is sure that there is something
drawn in the solder stop layer. If you can not delete them in the layout
editor in EAGLE it is obviously something that comes from a library.
What if you try to move on of the components in this area? Do the solder
stop wires belong to one of the parts there? If yes, you have to check
the package definition......

Richard Hammerl

To view any images and attachments in this post, visit:
Previous Topic: Is the newsgroup going to be turned off?
Next Topic: The CAM Processor is automatically flooding the copper when creating gerber. Surface mount pads become shorted. What do I have setup incorrectly?
Goto Forum:

Current Time: Mon Oct 16 23:56:38 GMT 2017