EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.userchat.eng » The CAM Processor is automatically flooding the copper when creating gerber. Surface mount pads become shorted. What do I have setup incorrectly?
The CAM Processor is automatically flooding the copper when creating gerber. Surface mount pads become shorted. What do I have setup incorrectly? [message #165518] Thu, 21 April 2016 18:11 Go to next message
Wayne Mullon
Messages: 2
Registered: April 2016
Junior Member
The CAM Processor is automatically flooding the copper when creating
gerber. Surface mount pads become shorted. What do I have setup
incorrectly?

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/195123
Re: The CAM Processor is automatically flooding the copper when creating gerber. Surface mount pads become shorted. What do I have setup incorrectly? [message #165526 is a reply to message #165518] Thu, 21 April 2016 23:18 Go to previous messageGo to next message
Clem Martins
Messages: 251
Registered: December 2014
Senior Member
Jorge_Garcia (https://www.element14.com/community/people/Jorge_Garcia)
may know the parameter to change for this fill problem.
Clem

--
To view any images and attachments in this post, visit:
https://www.element14.com/community/message/195213
Re: The CAM Processor is automatically flooding the copper when creating gerber. Surface mount pads become shorted. What do I have setup incorrectly? [message #165584 is a reply to message #165518] Mon, 25 April 2016 09:14 Go to previous message
CadSoft Support
Messages: 538
Registered: September 2006
Senior Member
Am 21.04.2016 um 20:11 schrieb Wayne Mullon:
> The CAM Processor is automatically flooding the copper when creating
> gerber. Surface mount pads become shorted. What do I have setup
> incorrectly?
>
> --
> To view any images and attachments in this post, visit:
> https://www.element14.com/community/message/195123
>

What happens if you do a RATSNEST in the Layout Editor? Any errors in
the DRC?


--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Previous Topic: Re: Strange solder mask openings
Next Topic: Strange solder mask openings
Goto Forum:
  


Current Time: Sat Mar 25 23:33:02 GMT 2017