EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.userchat.eng » How to remove extra lines
How to remove extra lines [message #164321] Mon, 30 November 2015 19:50 Go to next message
Harry H. Arends
Messages: 44
Registered: March 2011
The attached lib contains one package. of a capacitor.
How do i remove the extra lines.
Sometimes i can remove extra line poarts, sometime not.
What could be the reason?


  • Attachment: Question.lbr
    (Size: 11.10KB, Downloaded 336 times)
Re: How to remove extra lines [message #164337 is a reply to message #164321] Wed, 02 December 2015 15:19 Go to previous message
David Pollum
Messages: 177
Registered: April 2005
Location: Virginia, USA
Senior Member
Basically, use the ARC command rather than the circle command. Temporarily change the layer of the circles to something else (i.e. top). Then click on ARC and start the arc at the "(" of your outline. Make the arc as big as the circle. Then move the cursor until it meets the other ")" of your outline. Do this until you get both of them to your liking. You may have to experiment. Then delete the original circles. HTH
-Dave Pollum
Previous Topic: Creating a board from one schematic of a project - Content for all schematics seen on board layout
Next Topic: Re: Eagle part for 0603 EMIFIL
Goto Forum:

Current Time: Fri Oct 20 07:19:02 GMT 2017