EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.userchat.eng » How can I edit a component (SMD resistor) after sending to the bottom side in the board view via the middle mouse button?
How can I edit a component (SMD resistor) after sending to the bottom side in the board view via the middle mouse button? [message #163802] Sat, 24 October 2015 21:21 Go to next message
Slap Shot
Messages: 1
Registered: October 2015
Junior Member
I seem completely unable to edit the component after I send it to the
bottom layer - I can't delete it, move it, or even group it - is the
bottom layer "locked" somehow, or can I switch to that view? is there
any way to group a bottom-layer component with a top-layer component?

--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/164854
Re: How can I edit a component (SMD resistor) after sending to the bottom side in the board view via the middle mouse button? [message #163805 is a reply to message #163802] Sat, 24 October 2015 22:59 Go to previous message
warrenbrayshaw
Messages: 1750
Registered: January 2010
Location: New Zealand
Senior Member
On 25/10/2015 10:21 a.m., Slap Shot wrote:
> I seem completely unable to edit the component after I send it to the
> bottom layer - I can't delete it, move it, or even group it - is the
> bottom layer "locked" somehow, or can I switch to that view? is there
> any way to group a bottom-layer component with a top-layer component?
>
> --
> To view any images and attachments in this post, visit:
> http://www.element14.com/community/message/164854
>


Hi
You probably have the layer bOrigins turned off

HTH
Warren
Previous Topic: Hard Lessons Learned (watch out for land mines)
Next Topic: CadSoft Eagle v7.5 Preview
Goto Forum:
  


Current Time: Sat Jun 24 15:38:38 GMT 2017