EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » How to avoid many DRC width errors when panelizing ? (Element 14 :: EAGLE Related Posts)
How to avoid many DRC width errors when panelizing ? [message #163425] Sun, 27 September 2015 17:13 Go to next message
messages@element14.co
Messages: 392
Registered: March 2013
Senior Member
I am trying to cramp as much design I can in a  small PCB  to reduce costs. I have properly made  each  design with no  DRC errors,and then used the panelized.ulp procedure to made the designs adequate for panelizing.  But when I import several on them in my   new board design, I got a huge amount of width errors, whatever the option I take.  Can you help ?  Thanks  Original article at http://www.element14.com/community/message/161803?tstart=0#161803.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: How to avoid many DRC width errors when panelizing ? [message #163430 is a reply to message #163425] Mon, 28 September 2015 09:04 Go to previous message
messages@element14.co
Messages: 392
Registered: March 2013
Senior Member
Hi, Please check your DRC settings. I suppose in the new board they are not the same as in the board file of your design. Regards,Richard Original article at http://www.element14.com/community/message/161813?tstart=0#161813.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Unable to activate Freemium license
Next Topic: Atmega32u4 QFN-44-NOPAD package
Goto Forum:
  


Current Time: Sat May 27 00:29:52 GMT 2017