EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.betatest » ERC Single Nets
ERC Single Nets [message #163325] Wed, 16 September 2015 17:39 Go to next message
Bob Starr
Messages: 99
Registered: April 2008
Member
This is more of a bug report I guess, sorry for posting here...

But, the ERC check for single nets does not check single ended nets
properly. It's still possible to have multiple net segment that still
don't physically connect to anywhere (maybe even off sheet). This makes
it easy to forget connecting a net somewhere in larger designs.

The single net ERC check only seems to check for more than one instance
of the same net name, rather than if it's actually connected or not
somewhere. Sure would like to see this fixed in some future release.

Thanks!

Bob
Re: ERC Single Nets [message #163391 is a reply to message #163325] Fri, 25 September 2015 07:50 Go to previous message
CadSoft Support
Messages: 542
Registered: September 2006
Senior Member
Am 16.09.2015 um 19:39 schrieb Bob Starr:
> This is more of a bug report I guess, sorry for posting here...
>
> But, the ERC check for single nets does not check single ended nets
> properly. It's still possible to have multiple net segment that still
> don't physically connect to anywhere (maybe even off sheet). This makes
> it easy to forget connecting a net somewhere in larger designs.
>
> The single net ERC check only seems to check for more than one instance
> of the same net name, rather than if it's actually connected or not
> somewhere. Sure would like to see this fixed in some future release.
>
> Thanks!
>
> Bob


Hi Bob,

could you please send me an example .sch?


--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Previous Topic: 7.1.3 unintended ripup bug
Next Topic:
Goto Forum:
  


Current Time: Tue Oct 17 09:33:16 GMT 2017