EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.betatest » EAGLE CAM Processor support for Gerber X2
EAGLE CAM Processor support for Gerber X2 [message #162783] Wed, 12 August 2015 15:23
Edwin Robledo
Messages: 2
Registered: June 2009
Junior Member
Hi Everyone, I hope all is well. We are getting a demand for EAGLE to
support Gerber X2. We would like to ask someone in the community if
they will be interested in adding this driver to the EAGLE CAM
Processor. Please do not reply on the forum!!, if you are interested in
finding out more information, please contact me at ed@cadsoftusa.com.
Specification can be found here: http://www.ucamco.com/en/guest/downloads
With Warm Regards, Ed
Previous Topic: ULP - copy-wire-to-any-layer.ulp misnamed
Next Topic: Beta version 7.3.3 available
Goto Forum:
  


Current Time: Wed Jun 28 00:07:18 GMT 2017