EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.userchat.eng » "use" libraries
"use" libraries [message #161571] Thu, 25 June 2015 08:34 Go to next message
Robert von Knobloch
Messages: 42
Registered: May 2011
Member
Where does Eagle store the "use/not use" parameter of libraries.
Whenever I open Eagle, all the libs are marked as "use", I make my
selection/deselection, but this is not stored, next time they are all
set to use".
I see that the correct libs are referenced in the epf file, but they
seem not to be respected.
It makes no difference whether I open a project via Eagle's Menu system
(which I, personally, don't use) or assingeing eagle to a filetype
(Opensuse Linux).
(Eagle Version 7.2)
Many thanks,

Bob
Re: "use" libraries [message #161607 is a reply to message #161571] Mon, 29 June 2015 14:30 Go to previous message
CadSoft Support
Messages: 539
Registered: September 2006
Senior Member
Am 25.06.2015 um 10:34 schrieb Robert von Knobloch:
> Where does Eagle store the "use/not use" parameter of libraries.
> Whenever I open Eagle, all the libs are marked as "use", I make my
> selection/deselection, but this is not stored, next time they are all
> set to use".
> I see that the correct libs are referenced in the epf file, but they
> seem not to be respected.
> It makes no difference whether I open a project via Eagle's Menu system
> (which I, personally, don't use) or assingeing eagle to a filetype
> (Opensuse Linux).
> (Eagle Version 7.2)
> Many thanks,
>
> Bob


This is in the file eagle.epf, the current project file.


--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Previous Topic: 7.3.0 user interface issues
Next Topic: Copy tool loses window focus, requiring two clicks instead of one
Goto Forum:
  


Current Time: Mon Jun 26 07:14:28 GMT 2017