EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Electronics Lab :: EAGLE Related Articles » 3A Power supply for USB devices (Electronics Lab :: EAGLE Releated Articles)
3A Power supply for USB devices [message #160745] Thu, 07 May 2015 08:30
admin
Messages: 124
Registered: November 2008
Senior Member
Administrator

Jayakody published a new project, a 3A Power supply for USB devices:
This is 5V 3A power supply to drive two USB based devices simultaneously. This power supply is design around LM2576-5.0 switching regulator IC and the main reasons to choose this IC is its low parts count, small heat sink requirements and its inbuilt current limit protection feature.
We specially design this power supply to work with development boards / single board computer (SBC) platforms such as Raspberry Pi, Banana Pi, BeagleBone, etc. This power supply can also be used to provide power to USB OTG peripherals over USB Y cables. We test this setup and got successful results with Huawei Ascend P6 mobile phone.
3A Power supply for USB devices – [Link]Original article at http://www.electronics-lab.com/blog/?p=33902.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: How to generate 3D output with EAGLE and IDF-to-3D
Next Topic: Breadboard Power Supply
Goto Forum:
  


Current Time: Wed Sep 20 02:08:45 GMT 2017