EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Rotate Components Less than 90 degree (Element 14 :: EAGLE Related Posts)
Rotate Components Less than 90 degree [message #157605] Sun, 28 September 2014 05:17 Go to next message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
HiI have query on Rotate the components with circular board. I can rotate the component 90 degree rotation without any issue, i need to rotate the components 10 or 20 degree. when i rotate 10 ro 20 degree, iam getting lines and pads are creating like are bending like below. i would like to know how to rotate the component with component origin (component origin also should rotate) to avoid bending.Original article at http://www.element14.com/community/message/127349?tstart=0#127349.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Rotate Components Less than 90 degree [message #157633 is a reply to message #157605] Wed, 01 October 2014 07:54 Go to previous messageGo to next message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
Hello, I do not exactly understand what you would like to have changed. The "bended" lines are a matter of the graphics display. In reality on the board there will be proper drawn lines (depending on the resolution of the plotting device). Regards,RichardOriginal article at http://www.element14.com/community/message/127530?tstart=0#127530.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Rotate Components Less than 90 degree [message #157634 is a reply to message #157605] Wed, 01 October 2014 09:29 Go to previous message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
Hi Richard, I Mentioned that there is a zigzagged pads also got zigzagged lines, You mentioned "reality on the board there will be proper drawn lines", How i came to know that this will Really draw proper lines, is there any way to view this. RegardsAnilOriginal article at http://www.element14.com/community/message/127544?tstart=0#127544.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Eagle 7.1 Crashing
Next Topic: Eagle design link with no.farnell.com
Goto Forum:
  


Current Time: Sat Aug 19 05:29:29 GMT 2017