EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Metric? (Element 14 :: EAGLE Related Posts)
Metric? [message #157355] Mon, 08 September 2014 12:12 Go to next message
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member
How do I switch the UI so that traces, drill sizes etc are in metric rather than imperial?Original article at http://www.element14.com/community/message/125900?tstart=0#125900.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Metric? [message #157362 is a reply to message #157355] Tue, 09 September 2014 07:57 Go to previous messageGo to next message
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member

Andy Clark wrote:
 
How do I switch the UI so that traces, drill sizes etc are in metric rather than imperial?
 In the schematic or board editor type: SET Interface.PreferredUnit 2See HELP SET for details.Joop Original article at http://www.element14.com/community/message/125997?tstart=0#125997.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Metric? [message #157363 is a reply to message #157355] Tue, 09 September 2014 08:43 Go to previous messageGo to next message
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member
Thanks Joop I just tried that, the command was accepted without an error message but does not seem to have made any difference.Original article at http://www.element14.com/community/message/125983?tstart=0#125983.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Metric? [message #157365 is a reply to message #157355] Tue, 09 September 2014 08:53 Go to previous messageGo to next message
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member
type:   grid mm JoopOriginal article at http://www.element14.com/community/message/125999?tstart=0#125999.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Metric? [message #157366 is a reply to message #157355] Tue, 09 September 2014 08:59 Go to previous message
messages@element14.co
Messages: 378
Registered: March 2013
Senior Member
Cheers, that's done it. Many thanksOriginal article at http://www.element14.com/community/message/125984?tstart=0#125984.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: BB View 7" xbmc
Next Topic: Eagle 7.1 Crashing
Goto Forum:
  


Current Time: Tue Mar 28 02:22:58 GMT 2017