EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.announce.eng » Severe 7.1 issue
Severe 7.1 issue [message #157191] Mon, 25 August 2014 14:15
Morten Leikvoll
Messages: 1351
Registered: November 2007
Senior Member
(Not tested on 7.0)

Make a wire between any two components, route it name it "test" (make a
label on sch to show the name).

In sch, cpy all and paste it next to the original. Notice the new net
between the two new components have same name.
Now route the copy too, but dont connect the two copies.

Now, rename the net between the copied components.

Now here is the issue:7.1 now rips up that net at brd!

6.x is fully capable of resolving this at board level, wich is a feature I
very often use when making copies.

Please dont tell me you removed this by purpose.
Previous Topic: EAGLE version 7.1.0 released!
Next Topic: EAGLE version 7.2 released!
Goto Forum:

Current Time: Sun Sep 24 06:45:43 GMT 2017