EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Writing on PCB (Element 14 :: EAGLE Related Posts)
Writing on PCB [message #156276] Sun, 13 July 2014 07:02 Go to next message
messages@element14.co
Messages: 392
Registered: March 2013
Senior Member
Which of the layers is for writing on the PCB? like if I want it to say pin numbers, name of chip etcOriginal article at http://www.element14.com/community/message/120185?tstart=0#120185.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Writing on PCB [message #156278 is a reply to message #156276] Sun, 13 July 2014 15:13 Go to previous message
messages@element14.co
Messages: 392
Registered: March 2013
Senior Member
text layers25 top-of-card component names26 bottom-of-card component names27 top-of-card component values28 top-of-card component values25 top-of-card silk screen labelsAll of these end up on the silk screen. If you want some text in copper use  layer 1 for top of card and layer 16 for bottomhttps://www.youtube.com/watch?v=tna0XNjHkrwOriginal article at http://www.element14.com/community/message/120193?tstart=0#120193.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: looking for 2 digit 7-segment BCD decoder, 5 bit
Next Topic: Low voltage but no ground
Goto Forum:
  


Current Time: Sat May 27 00:26:16 GMT 2017