EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Electronics Lab :: EAGLE Related Articles » Polyimide (Kapton) PCB Solder Paste Stencil (Electronics Lab :: EAGLE Releated Articles)
Polyimide (Kapton) PCB Solder Paste Stencil [message #151719] Sun, 21 July 2013 19:24
Messages: 124
Registered: November 2008
Senior Member

cmiyc @ instructables.com writes:
Creating a solder paste stencil for a toaster reflow oven or hot plate is simple when you have access to a laser cutter. I used the Laser Cutter at my local TechShop to create this and other PCB stencils.
This Instructable assumes you have created a PCB and are able to generate the Gerber Files for it. Specific directions will be given for EAGLE, but other PCB software can be used. The board used in this example is an Arduino RTC Shield based on the DS3231. Follow the link for the EAGLE design files if you want to follow along.
Polyimide (Kapton) PCB Solder Paste Stencil - [Link]Original article at http://www.electronics-lab.com/blog/?p=22884.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Tiny Touch Button
Next Topic: USB to Serial Breakout Board for FTDI FT230X
Goto Forum:

Current Time: Thu Oct 19 10:40:06 GMT 2017