EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Electronics Lab :: EAGLE Related Articles » Eagle UPL: Create Drill Line Array (Electronics Lab :: EAGLE Releated Articles)
Eagle UPL: Create Drill Line Array [message #150521] Wed, 10 April 2013 19:47
Messages: 124
Registered: November 2008
Senior Member

Author: James Connors
Description: This ULP is quite creative and simple to use. Draw a 0 with wire on the milling layer. Run the ULP, the dialog box selection will provide options to either draw an array of holes or vias. Parameters such as Diameter, signal name amount of holes and distance can be defined.
Eagle UPL: Create Drill Line Array - [Link]Original article at http://www.electronics-lab.com/blog/?p=21497.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Build your own PICkit 2 programmer
Next Topic: Tom Hausherr’s Blog
Goto Forum:

Current Time: Tue Oct 17 11:26:04 GMT 2017