EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » Element 14 :: EAGLE Related Posts » Re: IPC-D-356 ulp, blind and buried vias (Element 14 :: EAGLE Related Posts)
Re: IPC-D-356 ulp, blind and buried vias [message #150377] Mon, 01 April 2013 15:07 Go to next message
hillig
Messages: 1
Registered: April 2013
Junior Member
Did this ever get resolved?  This would be very helpful to have. *************************************************************** I went ahead and roughed in 4-layer blind/buried via handling.  Passes check on at least 1 board.  Use at your own risk.Original article at http://www.element14.com/community/message/73122?tstart=0#73122.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Re: Re: IPC-D-356 ulp, blind and buried vias [message #156763 is a reply to message #150377] Fri, 01 August 2014 19:45 Go to previous message
messages@element14.co
Messages: 512
Registered: March 2013
Senior Member
Here is what I would up using on my 12 layer board (1-4-2-4-1) with blind and buried vias. It should work on all combinations up to 16 layers. No guarantees. Didn't know where to go with the "Version" info, so I called it 2.0.2xOriginal article at http://www.element14.com/community/message/122593?tstart=0#122593.

-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Previous Topic: Low voltage but no ground
Next Topic: Multiple sub-design in one design (easily in Eagle 5, hardly in Eagle 6)
Goto Forum:
  


Current Time: Sat Aug 19 05:26:42 GMT 2017