EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.suggest.eng » Move polygon
Move polygon [message #107245] Tue, 13 October 2009 12:54 Go to next message
Morten Leikvoll
Messages: 1347
Registered: November 2007
Senior Member
I copy and rotate polygons now and then, and it is a bit hard to place it
correctly at the first click, so I miss a "move: polygon" function in the
context menu.
Re: Move polygon [message #166227 is a reply to message #107245] Mon, 11 July 2016 13:28 Go to previous messageGo to next message
Lorenz
Messages: 644
Registered: December 2006
Senior Member
Morten Leikvoll wrote:

> I copy and rotate polygons now and then, and it is a bit hard to place it
> correctly at the first click, so I miss a "move: polygon" function in the
> context menu.

at least with eagle V6.6 you can select a whole polygon quite easyly.

Make sure you have an empty group (activate the group command and
select an empty reagion),
then ctrl-click (add to group) a segment of the polygon.
--

Lorenz
Re: Move polygon [message #166250 is a reply to message #166227] Thu, 14 July 2016 08:23 Go to previous message
Morten Leikvoll
Messages: 1347
Registered: November 2007
Senior Member
On 11.07.2016 15:28, Lorenz wrote:
> Morten Leikvoll wrote:
>
>> I copy and rotate polygons now and then, and it is a bit hard to place it
>> correctly at the first click, so I miss a "move: polygon" function in the
>> context menu.
>
> at least with eagle V6.6 you can select a whole polygon quite easyly.
>
> Make sure you have an empty group (activate the group command and
> select an empty reagion),
> then ctrl-click (add to group) a segment of the polygon.
>

After the 7.6.1 beta fix, I can, using an ULP, rightclick a polygon wire
and select move polygon from the context menu.

Imo, this feature deserves to become a standard feature in Eagle.
Previous Topic: Move polygon
Next Topic: PTH pads and hole
Goto Forum:
  


Current Time: Mon Jun 26 01:58:59 GMT 2017