EAGLE Central Forums
Where the EAGLE community meets. Sponsored by Stratford Digital.

Home » CadSoft Support Forums » eagle.announce.eng » EAGLE version 5.6 released!
EAGLE version 5.6 released! [message #63744] Mon, 04 May 2009 10:57
Klaus Schmidinger
Messages: 1460
Registered: November 2008
Senior Member
The new version 5.6 of EAGLE is now available for download at

http://www.cadsoft.de/download.htm

The changes since version 5.5 are:

* Bugfixes:

- Fixed RIPUP to make it stop at pads when clicking on an airwire
(was broken since version 5.2.4).
- Fixed a possible "Abort: Unknown objectType..." in the SIGNAL command.
- Fixed a bug in the Autorouter that sometimes caused DRC errors at pads,
vias and SMDs.
- Fixed the status message after a DRC or ERC, which sometimes wrongfully
contained the word "approved".
- Fixed a possible inconsistency of net classes after renaming all segments
of a net on the current sheet.
- Fixed a possible inconsistency of net classes after pasting parts with
power pins that automatically create new signals in the board.
- Fixed handling cfPad/SmdImpact in the Autorouter.
- Fixed terminating a track in the Follow-me router by clicking twice at the
same point.
- Fixed an unexpected offset of the airwire when clicking at an unroutable
point in the Follow-me router.

Klaus Schmidinger
--
____________________________________________________________ ___

Klaus Schmidinger Phone: +49-8635-6989-10
CadSoft Computer GmbH Fax: +49-8635-6989-40
Hofmark 2 Email: kls@cadsoft.de
D-84568 Pleiskirchen, Germany URL: www.cadsoft.de
____________________________________________________________ ___
Previous Topic: EAGLE version 5.5 released!
Next Topic: *** Top Layer Jumpers on SS Boards ***
Goto Forum:
  


Current Time: Fri Jul 21 08:47:49 GMT 2017