EAGLE Central Forums: sci.electronics.design :: EAGLE Related Posts » Re: using a synchronous rectifier in a boost circuit

Home » EAGLE Related Forums, Blogs, ... (Read-Only) » sci.electronics.design :: EAGLE Related Posts » Re: using a synchronous rectifier in a boost circuit (sci.electronics.design :: EAGLE Related Posts)

Show: Today's Messages :: Show Polls :: Message Navigator

Re: using a synchronous rectifier in a boost circuit [message #127448]

Mon, 28 June 2010 23:22

jmor...@shaw.ca (Jami is currently offline

jmor...@shaw.ca (Jami
Messages: 1
Registered: June 2010

Junior Member

Hi,
I am using an off the shelf ATX power factor corrected 750Watt
powersupply as the 12VDC input, and then boosting this to ~13.5VDC for
charging lead acid batteries at 600watts+. This is part of my "ATX
power tower" project, a cheap home energy system in a PC case :)
Its going to be open source, and designed in eagle cad. Here are some-- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.

Report message to a moderator

Previous Topic:	Caveats for Multi Layer Boards?
Next Topic:	Re: Bad Omen?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Wed Sep 08 19:09:12 EDT 2010

.:: Contact :: Home ::.